Utilisateur

I have a Nissan Xterra 2007, I purchased a EVO One with T-Harness and RF642W RF Kit. I'm using install guide 33131 for EVO one. I wired per instructions with A1,A2,A3,A8,A15 | E harnes by T-Harness, C3,C4, and D6,D4. D1 & D3 do not plug into anything and have been set aside. Held down Bypass Prog Button when inserting 6-pin power plug. I let LED cylce through once and waited for blue light and release bypass prog button and pluged in 20-pin, 6-pin bypass relay, 5-pin can bus, and 4-pin data link ant while the light stayed blue. I insert key into ignition chamber and turn to ON. Blue goes off then flashed blue. I turn key to off. Programming should be complete. 3X lock on OEM remote does not remote start. I insert key into ignition and turn to ON and the EVO One lights up yellow. I use the flashlink to update bypass to 72.27 and the remote start to 1.21. In bypass I enable C1 & D2. EVO still does the same thing when pluged into vehicle. I try using programming button but holding it down for 1+ minute with no horn beep. I suspect wiring was not correct. I double checked and have CAN-high and CAN-low correct. A1 is on (+) ignition (Pink-E5). A2 & A3 are on wiring diagram pin 14 & 13 but on vehicle BCS/BCM manual terminal is 8 & 7. A8 did not corispond with Wirecolor.com picture, image shows incorrect junction terminals for US version of Xterra. voltmetered 4 different plugs and no luck. According to vehicle BCS/BCM manual, driver door command is a Gray wire at M19 harness pin 47 next to 40-pin harness. When locking and unlocking the EVO one does not light up. I can't tell if OEM alarm is being set by Cars BCS/BCM or if it by the EVO One but the alarm does activate on door trip. Remote Start Programming: 2.3 | 3 (1) | 4.1 | 6.3 | 7.1 | 8.2 | 9.1 | 11.1 &11.4 | 12.1 | 13.2 | 14.2 | 15.2 | 16.5 | 18.1 | 19.1| 20.1 | 21.1 | 24.1 | 25.1 | 26.1 | 29.1 | 30.1 | 31.1 | 32.3 | 33.1 | 34-OFF-OFF| 35.1 | 36.2 | 37.1 | 38.1 (38.3-Off) | 39.1 Bypass Programming: A1-A11 - ON | B1-OFF| C1-ON| D2-ON| D3-D6 -OFF Unit Options : D.1 | D1.6 | H1 are enabled. I have master reset both side of EVO-One and started fresh with first paragraph and no luck, just same results. Any thoughts on where to look for the issue. I can grab field mesurements if desired.